CHINESE JOURNAL OF ENERGETIC MATERIALS
+高级检索
柱锥结合罩射流成型过程试验研究
作者:
作者单位:

作者简介:

通讯作者:

基金项目:


Experimental Investigation of Jet Formation of Cylinder-Cone Shaped Charge
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    为了更好地研究柱锥结合罩射流成型过程,采用300 kV脉冲X光机试验研究了柱锥结合罩弹射流形成过程,并进行了数值模拟对比分析。共进行九发子弹爆炸试验,得到18幅不同时刻的射流照片。研究了射流头部速度、射流长度时程曲线等变化规律。研究结果表明: 柱锥结合罩圆柱部分仅仅形成低速杵体,对破甲子弹射流质量和速度的贡献很小;受“激波效应”影响,射流头部速度(6738 m·s-1)小于数值模拟值(6824 m·s-1)。

    Abstract:

    In order to study jet formation of the cylinder-cone liner,the formation of cylinder-cone shaped charge was studied by using 300 kV pulse X-ray apparatus. The jet formation of shaped charge was analyzed by numerical simulation. Eighteen X-ray photographs were obtained from 9 experiments. The radiographs of the liner collapse were analyzed at different times. Curves of the jet tip velocity and the jet length vs time were obtained. The results show that the cylinder part of the liner can only produce low speed slug, which has no contribution to increasing the mass and velocity of the jet. Because of the “effects of shock wave”,the jet tip velocity is smaller than that by numerical simulation.

    参考文献
    相似文献
    引证文献
文章指标
  • PDF下载次数:
  • HTML阅读次数:
  • 摘要点击次数:
  • 引用次数:
引用本文

顾文彬,瞿洪荣,唐勇.柱锥结合罩射流成型过程试验研究[J].含能材料, 2009, 17(4):470-474. DOI:10.3969/j. issn.1006-9941.2009.04.023.
GU Wen-bin, QU Hong-rong, TANG Yong. Experimental Investigation of Jet Formation of Cylinder-Cone Shaped Charge[J]. Chinese Journal of Energetic Materials, 2009, 17(4):470-474. DOI:10.3969/j. issn.1006-9941.2009.04.023.

复制
历史
  • 收稿日期: 2008-11-17
  • 最后修改日期: 2009-03-11
  • 录用日期:
  • 在线发布日期: 2011-11-04
  • 出版日期: 2009-08-25