CHINESE JOURNAL OF ENERGETIC MATERIALS
+高级检索
表面活性剂的HLB值对HMX/聚氨酯基炸药油墨流变性能的影响
作者:
作者单位:

(1. 中北大学化工与环境学院, 山西 太原 030051; 2. 山西省超细粉体工程技术研究中心, 山西 太原 030051; 3. 四川省新型含能材料军民融合协同创新中心, 四川 绵阳 621000)

作者简介:

徐传豪(1991-),男,在读博士,主要从事新型传爆药研究。e-mail: 18434363821@126.com 通信联系人: 安崇伟(1980-),男,副教授,主要从事始发与中继能源技术研究。e-mail: anchongwei@yeah.com

通讯作者:

安崇伟(1980-),男,副教授,主要从事始发与中继能源技术研究。e-mail: anchongwei@yeah.com

基金项目:

山西省研究生教育创新项目资助(2016BY119); 山西省优势学科攀升计划支持


Effect of HLB Numbers of Surfactants on the Rheological Property of HMX/Polyurethane Based Explosive Ink
Author:
Affiliation:

(1. Chemical Industry and Ecology Institute, North University of China, Taiyuan 030051, China; 2. Shanxi Engineering Technology Research Center for Ultrafine Powder, Taiyuan 030051, China; 3. Sichuan Co-Innovation Center for New Energetic Materials, Mianyang 621000, China)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 支撑附件
    摘要:

    为研究表面活性剂的亲水疏水平衡值(HLB值)对炸药油墨流变性能的影响, 选取Span-80和Tween-80两种非离子表面活性剂, 调节其质量比配制出5组不同HLB值的混合表面活性剂, 采用Brookfield(CPS)流变仪对添加表面活性剂的细化环四亚甲基四硝胺(HMX)/聚氨酯基炸药油墨进行粘度测试, 并计算出非牛顿指数、屈服值及触变指数(TI值)。结果表明, 未添加表面活性剂的炸药油墨的非牛顿指数为0.024, 屈服值为467.08 Pa, TI值为36.82;表面活性剂的加入能够有效改善炸药油墨的流变性能。随着HLB值的升高, 炸药油墨表观粘度在剪切速率为5~100 s-1时先升高后降低, 非牛顿指数和TI值呈波动变化, 屈服值持续降低。当HLB值为11时, 炸药油墨的非牛顿指数达到最大值0.56, 屈服值达到5.38 Pa, TI值达到最小, 为8.26, 分别为未添加表面活性剂炸药油墨的23.33倍, 1.15%和21.53%。HLB值为11的表面活性剂更有利于改善炸药油墨的流变性能。

    Abstract:

    In order to investigate the effect of hydrophile-lipophile balance (HLB) numbers on the rheological properties of explosive inks, two nonionic surfactants of Span-80 and Tween-80 were selected to obtain 5 kinds of mixed surfactants with different HLB number by adjusting mass percentage. Whereafter, the viscosity of explosive ink with mixed surfactants was tested by means of Brookfield (CPS) rheometer and non-Newtonian index, yield values and thixotropic index(TI) were calculated at same time. Results indicate that for the explosive ink without surfactant the non-ewtonian index is 0.024, yield value is 467.08 Pa and TI value is 36.82, respectively, and the rheological properties of explosive ink will be effectively improved with the addition of surfactants. With the increasing of HLB number, the apparent viscosity of explosive ink will keep up at first and then down with the shear rate ranging from 5 s-1to 100 s-1. Meanwhile, non-Newtonian index and TI values fluctuate while yield vales continuously decrease. When HLB number is 11, the non-Newtonian index reaches the maximum 0.56, while the yield value attains the optimum value 5.38 Pa with TI value being the minimum 8.26, which are 23.33 times, 1.15% and 21.53% respectively compared with those of the explosive ink without surfactants. The surfactant with whose HLB number is 11 performs best in improving rheological property of explosive ink.

    参考文献
    相似文献
    引证文献
文章指标
  • PDF下载次数:
  • HTML阅读次数:
  • 摘要点击次数:
  • 引用次数:
引用本文

徐传豪,安崇伟,王晶禹,等.表面活性剂的HLB值对HMX/聚氨酯基炸药油墨流变性能的影响[J].含能材料, 2017, 25(9):745-749. DOI:10.11943/j. issn.1006-9941.2017.09.008.
XU Chuan-hao, AN Chong-wei, WANG Jing-yu, et al. Effect of HLB Numbers of Surfactants on the Rheological Property of HMX/Polyurethane Based Explosive Ink[J]. Chinese Journal of Energetic Materials, 2017, 25(9):745-749. DOI:10.11943/j. issn.1006-9941.2017.09.008.

复制
历史
  • 收稿日期: 2016-10-08
  • 最后修改日期: 2017-06-09
  • 录用日期: 2017-06-13
  • 在线发布日期: 2017-09-22
  • 出版日期: 2017-09-29